Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT
RM2070E _59 Vehicle Exterior _061950 DOOR / HATCH _0301883 BACK DOOR SUPPORT A

DOOR / HATCH  BACK DOOR SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 68945 1.INSTALL BACK DOOR UPPER DAMPER STAY BRACKET

a.

Clean the threaded portion on the vehicle body with a non-residue solvent.


b.

Apply adhesive to the threads of the 2 bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Install a new back door upper damper stay bracket with the 2 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 68961 2.INSTALL BACK DOOR STAY BOLT

a.

Clean the threaded portion on the vehicle body with a non-residue solvent.


b.

Apply adhesive to the threads of the back door stay bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Install the back door stay bolt.

Torque:
27 N*m (275 kgf*cm, 20 ft.*lbf)


Hide 68960 3.INSTALL BACK DOOR STAY ASSEMBLY

NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any horizontal load to the door stay in order to prevent the rod from deforming.



a.

When reusing the back door stay assembly:

i.
B275246

Install the 2 stop rings to the back door stay assembly.



b.
B275243

Install the back door stay assembly.

NOTICE:

Install the back door stay assembly while supporting the back door by hand.



c.

Check that the back door stay assembly is engaged in the ball joint and that the back door stay assembly cannot be pulled out.