When the mirror heater switch (rear window defogger switch) on the air conditioning control assembly (center cluster module circuit) is pressed, the operation signal is transmitted to the air conditioning amplifier assembly through a LIN communication line. When the air conditioning amplifier assembly receives the signal, it turns on the No. 1 integration relay to operate the mirror heater.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
If the auxiliary battery voltage becomes low, mirror heater operation is canceled to prioritize supplying power to the power steering system.
Check the rear window defogger operation.
The rear window defogger operates normally.
OK
NG
(See pageVehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical /Air Conditioner / Active Test.
Perform an Active Test according to the display on the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Defogger Relay (Rear) | Mirror heater | OFF/ON | Operate with power switch on (IG) |
| Result | Proceed to |
|---|---|
| Mirror heater operation on both mirrors is normal | A |
| Mirror heater operation on both mirrors is not normal | B |
| Mirror heater operation on RH mirror is not normal | C |
| Mirror heater operation on LH mirror is not normal | D |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C
D
Remove the No. 1 integration relay (See page Power Source / Network>POWER DISTRIBUTION>INTEGRATION RELAY>REMOVAL).
Disconnect the O12 outer rear view mirror assembly LH connector.
Disconnect the N12 outer rear view mirror assembly RH connector.
Measure the resistance according to the value(s) in the table below
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1I-2 (MHTR) - O12-3 (HL+) | Always | Below 1 Ω |
| 1I-2 (MHTR) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the No. 1 integration relay (See page Power Source / Network>POWER DISTRIBUTION>INTEGRATION RELAY>REMOVAL).
Disconnect the O12 outer rear view mirror assembly LH connector.
Disconnect the N12 outer rear view mirror assembly RH connector.
Measure the resistance according to the value(s) in the table below
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1I-2 (MHTR) - N12-3 (HR+) | Always | Below 1 Ω |
| 1I-2 (MHTR) - Body ground | Always | 10 kΩ or higher |
| N12-8 (HR-) - Body ground | Always | Below 1 Ω |
OK
NG
Remove the No. 1 integration relay (See page Power Source / Network>POWER DISTRIBUTION>INTEGRATION RELAY>REMOVAL).
Disconnect the O12 outer rear view mirror assembly LH connector.
Disconnect the N12 outer rear view mirror assembly RH connector.
Measure the resistance according to the value(s) in the table below
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1I-2 (MHTR) - O12-3 (HL+) | Always | Below 1 Ω |
| 1I-2 (MHTR) - Body ground | Always | 10 kΩ or higher |
| O12-8 (HL-) - Body ground | Always | Below 1 Ω |
OK
NG