Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR
RM2070E _59 Vehicle Exterior _061951 MIRROR (EXT) _0301887 OUTER REAR VIEW MIRROR G

MIRROR (EXT)  OUTER REAR VIEW MIRROR  INSPECTION  


PROCEDURE

Hide 87940 1.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH

a.

Inspect the operation of the mirror surface.

i.
B225734E02
1.979,3.542 1.979,2.969 1.979,2.969 2.5,2.969 false 1.875,3.542 1.875,2.969 1.875,2.969 1.354,2.969 false 2.104,3.594 2.5,3.594 false 0.5,2.708 0.688,2.875 0.188,0.167 12 false *a 2.542,2.896 2.698,3.031 0.156,0.135 10 false M+ 2.542,3.5 2.698,3.635 0.156,0.135 10 false MV 1.135,2.896 1.292,3.031 0.156,0.135 10 false MH

Disconnect the outer rear view mirror assembly LH connector.


ii.

Apply auxiliary battery voltage and check the operation of the mirror.

OK:
Measurement Condition Specified Condition
Auxiliary battery positive (+) → Terminal 6 (MV)
Auxiliary battery negative (-) → Terminal 5 (M+)
Turns upward
Auxiliary battery positive (+) → Terminal 5 (M+)
Auxiliary battery negative (-) → Terminal 6 (MV)
Turns downward
Auxiliary battery positive (+) → Terminal 4 (MH)
Auxiliary battery negative (-) → Terminal 5 (M+)
Turns left
Auxiliary battery positive (+) → Terminal 5 (M+)
Auxiliary battery negative (-) → Terminal 4 (MH)
Turns right


Text in Illustration
*a Component without harness connected
(Outer Rear View Mirror Assembly LH)

If the result is not as specified, replace the outer rear view mirror assembly LH.



b.

Check the mirror heater.

i.
B277126E03
1.583,3.552 1.583,2.76 1.583,2.76 1.75,2.76 false 1.479,3.75 1.479,4.271 1.479,4.271 1.646,4.271 false 0.708,2.646 0.875,2.813 0.167,0.167 10 false *a 1.802,2.677 2.083,2.844 0.281,0.167 10 false HL+ 1.698,4.198 1.979,4.365 0.281,0.167 10 false HL-

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 (HL+) - 8 (HL-) 25°C (77°F) 7.6 to 11.4 Ω


Text in Illustration
*a Component without harness connected
(Outer Rear View Mirror Assembly LH)

If the result is not as specified, replace the outer rear view mirror assembly LH.



Hide 87966 2.INSPECT OUTER MIRROR RETRACTOR LH

a.

Inspect the operation of the retractable mirror.

NOTICE:
·

Disconnect and reconnect the auxiliary battery between each mirror position check.

·

The mirror position cannot be changed manually when the auxiliary battery is connected. To change the mirror position manually, the auxiliary battery must be disconnected first.



i.
B199933E11
0.086,0.035 0.237,0.172 0.151,0.137 10 *a 1.184,0.035 1.334,0.172 0.151,0.137 10 *1 0.894,0.809 1.045,0.947 0.151,0.137 10 *2 1.033,1.645 1.184,1.782 0.151,0.137 10 *3 1.423,1.851 1.574,1.988 0.151,0.137 10 *4 2.031,2.026 2.182,2.164 0.151,0.137 10 *5 2.351,2.879 2.587,3.016 0.235,0.137 10 MR 2.008,3.195 2.229,3.332 0.220,0.137 10 MF 2.012,2.958 2.33,2.958 false 1.861,3.002 1.861,3.28 1.861,3.28 1.989,3.28 false

Disconnect the outer rear view mirror assembly LH connector.


ii.

For each position: Disconnect the auxiliary battery, set the mirror position by hand, connect the auxiliary battery, and check the retractable mirror's movement.

OK:
Tester Connection Condition Specified Condition
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Forward position (A) Moves from (A) to (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Forward position (A) Does not move
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Position between forward position (A) and driving position (C) Moves from (B) to (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Position between forward position (A) and driving position (C) Moves from (B) to (A)
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Driving position (C) Moves from (C) to (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Driving position (C) Does not move
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Position between driving position (C) and retracted position (E) Moves from (D) to (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Position between driving position (C) and retracted position (E) Moves from (D) to (C)
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Retracted position (E) Does not move
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Retracted position (E) Moves from (E) to (C)


Text in Illustration
*1 (A) Forward Position
*2 (B)
*3 (C) Driving position
*4 (D)
*5 (E) Retracted Position
*a Component without harness connected
(Outer Rear View Mirror Assembly LH)

If the result is not as specified, replace the outer rear view mirror assembly LH.



Hide 87910 3.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH

a.

Inspect the operation of the mirror surface.

i.
B225733E01
1.305,2.712 1.543,2.861 0.238,0.149 10 MH 2.456,2.317 2.694,2.466 0.238,0.149 10 M+ 2.456,2.73 2.694,2.879 0.238,0.149 10 MV 0.768,2.816 0.919,2.965 0.151,0.149 10 *a 2.079,3.545 2.079,2.806 2.079,2.806 2.415,2.806 false 1.976,3.545 1.976,2.408 1.976,2.408 2.413,2.408 false 1.873,3.545 1.873,2.806 1.873,2.806 1.609,2.806 false

Disconnect the outer rear view mirror assembly RH connector.


ii.

Apply auxiliary battery voltage and check the operation of the mirror.

OK:
Measurement Condition Specified Condition
Auxiliary battery positive (+) → Terminal 6 (MV)
Auxiliary battery negative (-) → Terminal 5 (M+)
Turns upward
Auxiliary battery positive (+) → Terminal 5 (M+)
Auxiliary battery negative (-) → Terminal 6 (MV)
Turns downward
Auxiliary battery positive (+) → Terminal 4 (MH)
Auxiliary battery negative (-) → Terminal 5 (M+)
Turns left
Auxiliary battery positive (+) → Terminal 5 (M+)
Auxiliary battery negative (-) → Terminal 4 (MH)
Turns right


Text in Illustration
*a Component without harness connected
(Outer Rear View Mirror Assembly RH)

If the result is not as specified, replace the outer rear view mirror assembly RH.



b.

Check the mirror heater.

i.
B277125E03
1.583,3.552 1.583,2.76 1.583,2.76 1.76,2.76 false 1.479,3.75 1.479,4.271 1.479,4.271 1.656,4.271 false 0.771,2.667 0.948,2.813 0.177,0.146 10 false *a 1.802,2.677 2.115,2.844 0.313,0.167 10 false HR+ 1.698,4.188 1.979,4.354 0.281,0.167 10 false HR-

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 (HR+) - 8 (HR-) 25°C (77°F) 7.6 to 11.4 Ω


Text in Illustration
*a Component without harness connected
(Outer Rear View Mirror Assembly RH)

If the result is not as specified, replace the outer rear view mirror assembly RH.



Hide 87946 4.INSPECT OUTER MIRROR RETRACTOR RH

a.

Inspect the operation of the retractable mirror.

NOTICE:
·

Disconnect and reconnect the auxiliary battery between each mirror position check.

·

The mirror position cannot be changed manually when the auxiliary battery is connected. To change the mirror position manually, the auxiliary battery must be disconnected first.



i.
B199932E12
0.126,0.083 0.277,0.222 0.151,0.138 10 *a 2.12,0.083 2.271,0.222 0.151,0.138 10 *1 2.406,0.897 2.557,1.035 0.151,0.138 10 *2 2.235,1.688 2.386,1.826 0.151,0.138 10 *3 2.409,2.88 2.646,3.018 0.238,0.138 10 MR 1.955,3.222 2.176,3.360 0.220,0.138 10 MF 1.834,1.905 1.984,2.043 0.151,0.138 10 *4 1.217,2.132 1.368,2.270 0.151,0.138 10 *5 1.856,3.007 1.856,3.315 1.856,3.315 1.936,3.315 false 2.012,2.96 2.386,2.96 false

Disconnect the outer rear view mirror assembly RH connector.


ii.

For each position: Disconnect the auxiliary battery, set the mirror position by hand, connect the auxiliary battery, and check the retractable mirror's movement.

OK:
Tester Connection Condition Specified Condition
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Forward position (A) Moves from (A) to (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Forward position (A) Does not move
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Position between forward position (A) and driving position (C) Moves from (B) to (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Position between forward position (A) and driving position (C) Moves from (B) to (A)
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Driving position (C) Moves from (C) to (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Driving position (C) Does not move
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Position between driving position (C) and retracted position (E) Moves from (D) to (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Position between driving position (C) and retracted position (E) Moves from (D) to (C)
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Retracted position (E) Does not move
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Retracted position (E) Moves from (E) to (C)


Text in Illustration
*1 (A) Forward Position
*2 (B)
*3 (C) Driving position
*4 (D)
*5 (E) Retracted Position
*a Component without harness connected
(Outer Rear View Mirror Assembly RH)

If the result is not as specified, replace the outer rear view mirror assembly RH.