Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR
RM2070E _59 Vehicle Exterior _061951 MIRROR (EXT) _0301887 OUTER REAR VIEW MIRROR A

MIRROR (EXT)  OUTER REAR VIEW MIRROR  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 87966 1.INSTALL OUTER MIRROR RETRACTOR

a.
B314429

Pass a new wire harness through a new frame sub-assembly.


b.
B314430

Connect the connector.


c.
B314431

Temporarily install the frame sub-assembly with the guide as shown in the illustration.


d.
B314427

Install the frame sub-assembly with the 2 screws.


e.
B314426

Connect the 2 connectors.


f.

Engage the clamp.


g.
B314425

Install the mirror actuator with the 3 screws.


h.
B314424

Using a T25 "TORX" socket wrench, install the base with 3 new screws.

Torque:
3.6 N*m (37 kgf*cm, 32 in.*lbf)

NOTICE:

When installing the base, check that the wire harness is not caught between the base and housing. Failure to do so may cause a short circuit.



i.
B314432E01
2.402,1.792 2.571,1.964 0.169,0.171 10 *a 1.513,1.177 2.375,1.852 false 0.418,1.293 0.597,1.472 0.179,0.179 10 *b 1.396,1.011 0.617,1.368 false

Adjust the wire harness so that the marking is at the position shown in the illustration.

Text in Illustration
*a Marking
*b Clamp


j.

Engage the clamp.


k.
B314422

Engage the 3 guides and 2 claws.


l.
B314433

Engage the 3 claws and install a new lower cover as shown in the illustration.


m.
B314420

Install a new gasket.


n.
B314419

Wind vinyl tape around the wire harness to secure it.

NOTICE:

If the vinyl tape is wrinkled, water may run down the wire harness and enter the vehicle. Make sure to wind the vinyl tape properly.



o.
B314434

Connect each connector with the adapter.


p.
B314435E01
0.584,2.598 0.768,2.771 0.184,0.173 10 *a 0.774,2.694 1.488,2.555 false

Route the longer wire harness as shown in the illustration.

Text in Illustration
*a Wire harness routing


q.
B314436E01
1.735,1.615 1.846,1.780 0.111,0.165 10 a 0.981,0.231 1.166,0.398 0.185,0.168 10 *1 1.171,0.336 1.703,0.872 false

Wind vinyl tape around the wire harness to secure it.

Text in Illustration
*1 Vinyl Tape

Reference Measurement
Area Measurement
a 40.0 mm (1.57 in.)