87961
1.REMOVE OUTER MIRROR
Push the outside part of the outer mirror assembly and tilt it as shown in the illustration.
Push the upper part of the mirror surface and tilt it.
| *1 | Protective Tape |
Apply protective tape as shown in the illustration.
Using a moulding remover, disengage the 2 claws at the lower part of the outer mirror as shown in the illustration.
Do not pull the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.
Disengage the 2 guides as shown in the illustration.
Disconnect the 2 connectors and remove the outer mirror.