Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM › 2012.03–2014.11
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301891 WIPER AND WASHER SYSTEM J

WIPER / WASHER  WIPER AND WASHER SYSTEM  IG Power Source Circuit  


DESCRIPTION

This circuit provides power to the headlight cleaner control relay.

WIRING DIAGRAM

E142597E29
4.936,2.521 5.250,2.707 0.314,0.186 10 A44 4.936,2.708 7.009,2.894 2.073,0.186 10 Headlight Cleaner Control Relay 0.584,1.062 1.990,1.245 1.406,0.182 10 from IG1 NO. 1 Relay 5.453,1.052 5.759,1.252 0.306,0.200 10 IG 5.453,2.136 5.666,2.336 0.213,0.200 10 E 5.231,2.05 5.405,2.201 0.174,0.150 10 4 5.241,0.953 5.428,1.132 0.187,0.179 10 3 3.373,1.211 4.407,1.407 1.034,0.196 10 ECU-IG NO. 2

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER CONTROL RELAY - IG CIRCUIT AND BODY GROUND)
a.

Disconnect the A44 headlight cleaner control relay connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A44-3 (IG) - Body ground Power switch off Below 1 V
Power switch on (IG) 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A44-4 (E) - Body ground Always Below 1 Ω




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR