Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM › 2012.03–2014.11
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301891 WIPER AND WASHER SYSTEM J

WIPER / WASHER  WIPER AND WASHER SYSTEM  Headlight Cleaner Motor and Relay Circuit  


DESCRIPTION

The headlight cleaner control relay controls the headlight cleaner motor and pump assembly.

WIRING DIAGRAM

E181449E05
0.125,1.073 1.01,1.688 0.885,0.615 10 false from Auxiliary Battery 1.781,1.438 3.271,1.99 1.49,0.552 10 false Headlight Cleaner Motor and Pump Assembly 1.781,1.292 2.063,1.5 0.281,0.208 10 false A43 5.385,1.885 5.667,2.094 0.281,0.208 10 false A44 2,0.865 2.198,1.063 0.198,0.198 10 false 2 2.771,0.865 2.979,1.031 0.208,0.167 10 false 1 5.26,0.854 5.427,1.031 0.167,0.177 10 false 6 5.417,0.979 5.698,1.188 0.281,0.208 10 false PB 5.375,2.021 6.49,2.448 1.115,0.427 10 false Headlight Cleaner Control Relay

PROCEDURE

1.INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY
HINT:

The following check should be performed with the headlight cleaner motor and pump assembly installed to the washer jar.


a.

Fill the washer jar with washer fluid.


b.
E190232E07
0.054,0.03 0.237,0.190 0.183,0.161 10 *a

Connect a auxiliary battery positive (+) lead to terminal 2 of the headlight cleaner motor and pump assembly, and a auxiliary battery negative (-) lead to terminal 1.


c.

Check that washer fluid flows from the washer jar.

OK:

Washer fluid is pumped from the washer jar.


Text in Illustration
*a Component without harness connected
(Headlight Cleaner Motor and Pump Assembly)



OK

2.CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER MOTOR CIRCUIT)

NG

REPLACE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER MOTOR CIRCUIT)
a.

Connect the headlight cleaner motor and pump assembly connector.


b.

Disconnect the A44 headlight cleaner control relay connector.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A44-6 (PB) - Body ground Always 11 to 14 V




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR