This circuit provides power to the windshield wiper relay assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the L146 windshield wiper relay assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L146-2 (IG) - Body ground | Power switch on (IG) | 11 to 14 V |
| L146-16 (WIG) - Body ground | Power switch on (IG) | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L146-12 (E) - Body ground | Always | Below 1 Ω |
OK
NG