Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM › from 2014.11
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301891 WIPER AND WASHER SYSTEM J

WIPER / WASHER  WIPER AND WASHER SYSTEM  Wiper ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to the windshield wiper relay assembly.

WIRING DIAGRAM

E196302E08
4.894,2.549 5.233,2.736 0.339,0.186 10 L146 4.894,2.736 7.055,2.922 2.161,0.186 10 Windshield Wiper Relay Assembly 0.598,0.922 2.015,1.105 1.417,0.182 10 from IG1 NO. 2 Relay 5.453,0.912 5.759,1.112 0.306,0.200 10 IG 5.453,2.15 5.666,2.350 0.213,0.200 10 E 5.203,2.064 5.377,2.215 0.174,0.150 10 12 5.273,0.813 5.397,0.992 0.125,0.179 10 2 3.703,1.043 4.256,1.239 0.552,0.196 10 WIP 0.598,1.504 2.029,1.686 1.431,0.182 10 from IG1 NO. 1 Relay 3.364,1.68 4.438,1.876 1.073,0.196 10 ECU-IG NO. 2 5.467,1.52 5.784,1.719 0.317,0.200 10 WIG 5.203,1.434 5.377,1.584 0.174,0.150 10 16

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - AUXILIARY BATTERY AND BODY GROUND)
a.

Disconnect the L146 windshield wiper relay assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
L146-2 (IG) - Body ground Power switch on (IG) 11 to 14 V
L146-16 (WIG) - Body ground Power switch on (IG) 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L146-12 (E) - Body ground Always Below 1 Ω




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR