Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM › 2012.03–2014.11
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301891 WIPER AND WASHER SYSTEM J

WIPER / WASHER  WIPER AND WASHER SYSTEM  Washer Signal Circuit  


DESCRIPTION

The headlight cleaner control relay receives the windshield washer operation signal.

WIRING DIAGRAM

E182121E02
0.39,1.109 1.842,1.472 1.452,0.363 10 from Windshield Wiper Switch Assembly 5.009,1.874 7.067,2.030 2.059,0.156 10 Headlight Cleaner Control Relay 5.009,1.724 5.317,1.880 0.309,0.156 10 A44 5.415,0.968 5.876,1.124 0.461,0.156 10 FRWA 5.261,0.87 5.431,1.026 0.170,0.156 10 5

PROCEDURE

1.CHECK OPERATION
a.

Check the operation of the front wiper and washer system.

OK:

Front wiper and washer system operates normally.




OK

2.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER SWITCH ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY)

NG

2.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER SWITCH ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY)
a.

Disconnect the A44 headlight cleaner control relay connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A44-5 (FRWA) - Body ground Power switch on (IG)
Front washer switch off
11 to 14 V
Power switch on (IG)
Front washer switch on
Below 1 V




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR