Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER RUBBER
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301895 REAR WIPER RUBBER A

WIPER / WASHER  REAR WIPER RUBBER  REPLACEMENT  


PROCEDURE

Hide 85220R 1.REMOVE REAR WIPER BLADE ASSEMBLY

a.
E223612

Raise the wiper blade to the position where the claw detaches with a click sound as shown in the illustration and then remove the rear wiper blade assembly from the rear wiper arm.

NOTICE:
·

Be careful not to damage the claw.

·

Do not lower the wiper arm with the wiper blade removed. The arm tip may damage the back door glass surface.




Hide 85214R 2.REMOVE REAR WIPER RUBBER

a.
E223608E02
1.124,1.569 1.124,1.792 false 1.052,1.784 1.215,1.948 0.163,0.164 10 *1 2.651,0.535 2.814,0.699 0.163,0.164 10 *a 2.849,1.1 3.011,1.264 0.163,0.164 10 *b 2.941,1.551 3.104,1.715 0.163,0.164 10 *c

Lift and pull the end of the wiper rubber protrusion from the blade stopper as shown in the illustration.

Text in Illustration
*1 Stopper
*a Lightly Push
*b Lift
*c Pull

NOTICE:

Do not forcibly pull out the wiper rubber. The backing plates will be deformed or the blade claws will be damaged.


HINT:

Lightly pushing the rubber in the middle will allow it to be removed more easily.



b.
E223609

Remove the rear wiper rubber with the rear wiper rubber backing plates.


c.
E224849

Remove the rear wiper rubber backing plates from the rear wiper rubber.


Hide 85214R 3.INSTALL REAR WIPER RUBBER

a.
E224848

Install the rear wiper rubber backing plates to a new rear wiper rubber.

NOTICE:

Install the backing plates facing the correct direction.



b.
E223611E02
0.892,1.502 0.667,1.728 false 0.492,1.693 0.654,1.866 0.161,0.173 10 *1

Insert the wiper rubber from the front end of the wiper blade assembly to the rear end through the second claw as shown in the illustration.

Text in Illustration
*1 Stopper


c.

After pushing the wiper rubber through the rear end claw, allow it to stick out from the rear end stopper.


d.
E223618E02
1.065,1.62 1.257,1.795 0.192,0.175 10 *b 0.429,1.62 0.621,1.795 0.192,0.175 10 *a

Confirm that the claws of the rear wiper blade assembly are correctly inserted into the grooves of the rear wiper rubber.

Text in Illustration
*a Correct
*b Incorrect

NOTICE:

Do not forcibly slide the wiper rubber. The backing plates will be deformed or the blade claws will be damaged.



Hide 85220R 4.INSTALL REAR WIPER BLADE ASSEMBLY

a.
E223613

Temporarily install the rear wiper blade assembly to a rear wiper arm, engage the claw to install the rear wiper blade assembly as shown in the illustration.

NOTICE:

Be careful not to damage the claw.