Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH › 2012.03–2014.11
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301896 WIPER SWITCH G

WIPER / WASHER  WIPER SWITCH  INSPECTION  


PROCEDURE

Hide 84650 1.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (w/ Rain Sensor)

a.
U155143E03
1.25,1.146 0.979,0.719 false 1.427,1.135 1.427,0.719 false 1.635,1.146 1.771,0.719 false 1.031,1.156 0.719,0.896 false 1.073,1.448 0.406,1.625 false 1.177,1.448 0.635,1.906 false 1.292,1.438 0.833,2.177 false 1.396,1.438 1.302,2.177 false 1.979,1.438 2.198,2.052 false 2.156,1.438 2.625,2.083 false 1.531,3.219 2.417,2.615 false 1.615,3.625 2.542,3.896 false 1.531,3.354 2.677,2.99 false 1.563,3.5 2.708,3.49 false 1.625,1.448 1.833,2.083 false 2.01,1.135 2.146,0.708 false 2.219,1.146 2.542,0.708 false 0.188,0.094 0.385,0.281 0.198,0.188 10 false *a 0.313,1.198 0.667,1.417 0.354,0.219 10 false L48 0.479,0.771 0.688,0.938 0.208,0.167 10 false +2 0.833,0.521 1.042,0.688 0.208,0.167 10 false +1 1.281,0.521 1.49,0.688 0.208,0.167 10 false +B 1.698,0.521 1.906,0.688 0.208,0.167 10 false +S 0.625,2.198 0.938,2.365 0.313,0.167 10 false VR2 1.177,2.198 1.49,2.365 0.313,0.167 10 false VR1 0.26,1.938 0.677,2.104 0.417,0.167 10 false AUTO 0.26,1.604 0.406,1.771 0.146,0.167 10 false E 2.76,1.208 3.125,1.406 0.365,0.198 10 false L49 2.5,2.104 2.813,2.271 0.313,0.167 10 false C1R 2.052,2.063 2.365,2.229 0.313,0.167 10 false +1R 2.594,3.802 2.875,3.969 0.281,0.167 10 false P1 2.771,3.396 3.052,3.563 0.281,0.167 10 false P2 2.729,2.854 3.01,3.021 0.281,0.167 10 false P3 2.458,2.479 2.708,2.646 0.25,0.167 10 false P4 0.188,2.542 0.385,2.729 0.198,0.188 10 false *1 1.719,2.094 2.031,2.26 0.313,0.167 10 false WR 2.458,0.521 2.771,0.688 0.313,0.167 10 false EW 2.042,0.542 2.354,0.708 0.313,0.167 10 false WF

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Front Wiper Switch
Tester Connection Switch Condition Specified Condition
L48-3 (+1) - L48-1 (+S) OFF Below 1 Ω
AUTO
L48-3 (+1) - L48-2 (+B) MIST
LO
L48-2 (+B) - L48-4 (+2) HI
L48-9 (AUTO) - L48-10 (E) AUTO

Front Washer Switch
Tester Connection Switch Condition Specified Condition
L49-2 (EW) - L49-3 (WF) ON Below 1 Ω
OFF 10 kΩ or higher

Rear Wiper Switch
Tester Connection Switch Condition Specified Condition
L49-6 (C1R) - L49-2 (EW) OFF 10 kΩ or higher
L49-7 (+1R) - L49-2 (EW)
L49-6 (C1R) - L49-2 (EW) INT Below 1 Ω
L49-7 (+1R) - L49-2 (EW) HI Below 1 Ω

Rear Washer Switch
Tester Connection Switch Condition Specified Condition
L48-5 (WR) - L49-2 (EW) OFF 10 kΩ or higher
L49-7 (+1R) - L49-2 (EW)
L48-5 (WR) - L49-2 (EW) WASH Below 1 Ω
L48-5 (WR) - L49-2 (EW) ON + WASH Below 1 Ω
L49-7 (+1R) - L49-2 (EW)

Adjusting Ring*
Tester Connection Switch Condition Specified Condition
L48-7 (VR1) - L48-8 (VR2) P1 209 to 231 Ω
P2 114 to 126 Ω
P3 58.9 to 65.1 Ω
P4 Below 1 Ω


HINT:

*: The rain sensor sensitivity can be adjusted by the windshield wiper switch adjusting ring.


Text in Illustration
*1 Windshield Wiper Switch Assembly (Adjusting Ring Position)
*a Component without harness connected
(Windshield Wiper Switch Assembly)

If the result is not as specified, replace the windshield wiper switch assembly.


Hide 84650 2.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (w/o Rain Sensor)

a.
U191334E02
0.979,1.823 1.219,1.448 false 1.385,1.469 1.438,1.854 false 1.792,1.073 1.688,0.625 false 2.01,1.063 2.021,0.604 false 2.281,1.063 2.385,0.594 false 2.51,1.073 2.74,0.646 false 1.146,1.073 0.875,0.615 false 1.396,1.073 1.26,0.615 false 1.823,1.479 1.927,1.865 false 0.125,0.052 0.313,0.229 0.188,0.177 10 false *a 0.292,1.188 0.594,1.365 0.302,0.177 10 false L49 2.906,1.177 3.188,1.344 0.281,0.167 10 false L48 2.719,0.469 2.927,0.635 0.208,0.167 10 false +2 2.313,0.396 2.521,0.563 0.208,0.167 10 false +1 1.896,0.396 2.104,0.563 0.208,0.167 10 false +B 1.531,0.438 1.74,0.604 0.208,0.167 10 false +S 0.813,1.865 1.125,2.031 0.313,0.167 10 false C1R 1.302,1.885 1.635,2.052 0.333,0.167 10 false +1R 0.677,0.448 0.99,0.615 0.313,0.167 10 false EW 1.063,0.448 1.375,0.615 0.313,0.167 10 false WF 1.792,1.896 2.125,2.063 0.333,0.167 10 false WR

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Front Wiper Switch
Tester Connection Switch Condition Specified Condition
L48-4 (+S) - L48-2 (+1) OFF Below 1 Ω
INT
L48-3 (+B) - L48-2 (+1) MIST
LO
L48-3 (+B) - L48-1 (+2) HI

Front Washer Switch
Tester Connection Switch Condition Specified Condition
L49-2 (EW) - L49-1 (WF) ON Below 1 Ω
OFF 10 kΩ or higher

Rear Wiper Switch
Tester Connection Switch Condition Specified Condition
L49-5 (C1R) - L49-2 (EW) OFF 10 kΩ or higher
L49-4 (+1R) - L49-2 (EW)
L49-5 (C1R) - L49-2 (EW) INT Below 1 Ω
L49-4 (+1R) - L49-2 (EW) HI Below 1 Ω

Rear Washer Switch
Tester Connection Switch Condition Specified Condition
L48-10 (WR) - L49-2 (EW) OFF 10 kΩ or higher
L49-4 (+1R) - L49-2 (EW)
L48-10 (WR) - L49-2 (EW) WASH Below 1 Ω
L48-10 (WR) - L49-2 (EW) ON + WASH Below 1 Ω
L49-4 (+1R) - L49-2 (EW)


Text in Illustration
*a Component without harness connected
(Windshield Wiper Switch Assembly)

If the result is not as specified, replace the windshield wiper switch assembly.