84650
1.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (w/ Rain Sensor)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L48-3 (+1) - L48-1 (+S) | OFF | Below 1 Ω |
| AUTO | ||
| L48-3 (+1) - L48-2 (+B) | MIST | |
| LO | ||
| L48-2 (+B) - L48-4 (+2) | HI | |
| L48-9 (AUTO) - L48-10 (E) | AUTO |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L49-2 (EW) - L49-3 (WF) | ON | Below 1 Ω |
| OFF | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L49-6 (C1R) - L49-2 (EW) | OFF | 10 kΩ or higher |
| L49-7 (+1R) - L49-2 (EW) | ||
| L49-6 (C1R) - L49-2 (EW) | INT | Below 1 Ω |
| L49-7 (+1R) - L49-2 (EW) | HI | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L48-5 (WR) - L49-2 (EW) | OFF | 10 kΩ or higher |
| L49-7 (+1R) - L49-2 (EW) | ||
| L48-5 (WR) - L49-2 (EW) | WASH | Below 1 Ω |
| L48-5 (WR) - L49-2 (EW) | ON + WASH | Below 1 Ω |
| L49-7 (+1R) - L49-2 (EW) |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L48-7 (VR1) - L48-8 (VR2) | P1 | 209 to 231 Ω |
| P2 | 114 to 126 Ω | |
| P3 | 58.9 to 65.1 Ω | |
| P4 | Below 1 Ω |
*: The rain sensor sensitivity can be adjusted by the windshield wiper switch adjusting ring.
| *1 | Windshield Wiper Switch Assembly (Adjusting Ring Position) |
| *a | Component without harness connected
(Windshield Wiper Switch Assembly) |
If the result is not as specified, replace the windshield wiper switch assembly.
84650
2.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (w/o Rain Sensor)
for Light Control Switch LH Side Type
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L48-1 (+S) - L48-3 (+1) | OFF | Below 1 Ω |
| INT | ||
| L48-2 (+B) - L48-3 (+1) | MIST | |
| LO | ||
| L48-2 (+B) - L48-4 (+2) | HI |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L49-2 (EW) - L49-3 (WF) | ON | Below 1 Ω |
| OFF | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L49-6 (C1R) - L49-2 (EW) | OFF | 10 kΩ or higher |
| L49-7 (+1R) - L49-2 (EW) | ||
| L49-6 (C1R) - L49-2 (EW) | INT | Below 1 Ω |
| L49-7 (+1R) - L49-2 (EW) | HI | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L48-5 (WR) - L49-2 (EW) | OFF | 10 kΩ or higher |
| L49-7 (+1R) - L49-2 (EW) | ||
| L48-5 (WR) - L49-2 (EW) | WASH | Below 1 Ω |
| L48-5 (WR) - L49-2 (EW) | ON + WASH | Below 1 Ω |
| L49-7 (+1R) - L49-2 (EW) |
| *a | Component without harness connected
(Windshield Wiper Switch Assembly) |
If the result is not as specified, replace the windshield wiper switch assembly.
for Light Control Switch RH Side Type
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| L48-4 (+S) - L48-2 (+1) | OFF | Below 1 Ω |
| INT | ||
| L48-3 (+B) - L48-2 (+1) | MIST | |
| LO | ||
| L48-3 (+B) - L48-1 (+2) | HI |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| L49-2 (EW) - L49-1 (WF) | ON | Below 1 Ω |
| OFF | 10 kΩ or higher |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| L49-5 (C1R) - L49-2 (EW) | OFF | 10 kΩ or higher |
| L49-4 (+1R) - L49-2 (EW) | ||
| L49-5 (C1R) - L49-2 (EW) | INT | Below 1 Ω |
| L49-4 (+1R) - L49-2 (EW) | HI | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| L48-10 (WR) - L49-2 (EW) | OFF | 10 kΩ or higher |
| L49-4 (+1R) - L49-2 (EW) | ||
| L48-10 (WR) - L49-2 (EW) | WASH | Below 1 Ω |
| L48-10 (WR) - L49-2 (EW) | ON + WASH | Below 1 Ω |
| L49-4 (+1R) - L49-2 (EW) |
| *a | Component without harness connected
(Windshield Wiper Switch Assembly) |
If the result is not as specified, replace the windshield wiper switch assembly.