Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301896 WIPER SWITCH A

WIPER / WASHER  WIPER SWITCH  REMOVAL  


PROCEDURE

Hide 45286 1.REMOVE STEERING COLUMN COVER

NOTICE:

Removing the lower steering column cover in the incorrect order will cause the lower steering column cover to break.


a.

Release the tilt and telescopic lever, and fully extend and lower the steering column assembly.


b.

Lock the tilt and telescopic lever.


c.
E253039

Push the right and left sides of the lower steering column cover to disengage the 4 claws.


d.
E228916

Insert fingers into the opening of the tilt lever of the lower steering column cover to disengage the claw.

HINT:

Spread the claw to disengage it.



e.
E228917E02
1.534,2.024 1.119,2.024 false 0.961,1.942 1.136,2.096 0.175,0.154 10 *1

Turn the steering wheel assembly to the left.


f.

Using a screwdriver, disengage the claw as shown in the illustration.

Text in Illustration
*1 Protective Tape

HINT:

Tape the screwdriver tip before use.



g.
E228918E02
1.703,1.883 1.565,2.021 false 1.44,2.023 1.593,2.176 0.152,0.153 10 *1

Turn the steering wheel assembly to the right.


h.

Using a screwdriver, disengage the claw as shown in the illustration and remove the lower steering column cover.

Text in Illustration
*1 Protective Tape

HINT:

Tape the screwdriver tip before use.



i.
E228919

Disengage the claw and 2 pins, and remove the upper steering column cover.


Hide 84650 2.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

a.
E228920

Disconnect the 2 connectors.


b.

Disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.

NOTICE:

If the claw is pushed with excessive force, it may break.