Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH › 2012.03–2014.11
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301896 WIPER SWITCH G

WIPER / WASHER  WIPER SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 84650 1.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (w/ Rain Sensor)

a.
U155033E04
1.167,1.094 0.865,0.594 true 2.271,1.083 2.458,0.583 true 0.115,0.073 0.313,0.26 0.198,0.188 10 false *a 0.281,1.198 0.583,1.365 0.302,0.167 10 false L48 0.688,0.427 0.896,0.594 0.208,0.167 10 false +1 2.917,1.208 3.219,1.375 0.302,0.167 10 false L49 2.417,0.417 2.729,0.583 0.313,0.167 10 false EW

Check the front washer operation.

Text in Illustration
*a Component with harness connected
(Windshield Wiper Switch Assembly)

i.

Connect a voltmeter positive (+) lead to terminal L48-3 (+1) and a negative (-) lead to terminal L49-2 (EW).


ii.

Turn the power switch on (IG).


iii.

Turn the washer switch on and off, and check the voltage between terminals L48-3 (+1) and L49-2 (EW).

OK:

Voltage changes as shown in the illustration.


E353061E03
4.052,1.448 4.094,1.333 false 4.823,1.448 4.74,1.323 false 1.656,0.271 2.844,0.75 1.188,0.479 10 false Washer Switch: 1.021,0.896 2.698,1.333 1.677,0.438 10 false Voltage between terminals L48-3 (+1) and L49-2 (EW): 3.333,0.188 4.302,0.51 0.969,0.323 10 false ON 3.292,0.458 4.26,0.781 0.969,0.323 10 false OFF 2.927,0.833 3.896,1.156 0.969,0.323 10 false 11 to 14 V 3.365,1.135 4.333,1.458 0.969,0.323 10 false 0 V 2.531,1.458 4.396,1.688 1.865,0.229 10 false Approximately 0.5 seconds 4.677,1.458 6.719,1.677 2.042,0.219 10 false Approximately 2.2 seconds

If the result is not as specified, replace the windshield wiper switch assembly.



Hide 84650 2.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (w/o Rain Sensor)

a.
U191333E02
0.99,0.625 1.167,1.073 false 2.292,1.083 2.823,0.708 false 0.146,0.167 0.385,0.417 0.24,0.25 10 false *a 0.292,1.177 0.594,1.354 0.302,0.177 10 false L49 2.906,1.177 3.188,1.344 0.281,0.167 10 false L48 2.854,0.583 3.063,0.75 0.208,0.167 10 false +1 0.792,0.438 1.104,0.604 0.313,0.167 10 false EW

Check the front wiper intermittent operation.

Text in Illustration
*a Component with harness connected
(Windshield Wiper Switch Assembly)

i.

Connect a voltmeter positive (+) lead to terminal L48-2 (+1) and a negative (-) lead to terminal L49-2 (EW).


ii.

Turn the power switch on (IG).


iii.

Turn the wiper switch to the INT position.


iv.

Operate the intermittent wiper relay and check the voltage between terminals L48-2 (+1) and L49-2 (EW).

OK:

Voltage changes as shown in the illustration.


E136493E97
3.344,1.052 4.573,1.26 1.229,0.208 10 false 1.6 +/- 1 seconds 5.781,1.063 7.063,1.271 1.281,0.208 10 false 10.7 +/- 5 seconds 1.875,0.438 2.635,0.729 0.76,0.292 10 false 11 to 14 V 2.344,0.896 2.646,1.188 0.302,0.292 10 false 0V 0.219,0.667 1.896,0.885 1.677,0.219 10 false Voltage between terminals 2.594,0.073 3.125,0.271 0.531,0.198 10 false FAST: 4.375,0.073 4.917,0.292 0.542,0.219 10 false SLOW: 3.135,1.448 3.5,1.656 0.365,0.208 10 false Start 2.74,1.448 3.073,1.667 0.333,0.219 10 false Stop 5.594,1.448 6.021,1.688 0.427,0.24 10 false Start 4.792,1.448 5.167,1.656 0.375,0.208 10 false Stop 0.813,1.417 2.021,1.667 1.208,0.25 10 false Wiper Operation: 0.219,0.833 1.979,1.104 1.76,0.271 10 false L48-2 (+1) and L49-2 (EW):

If the result is not as specified, replace the windshield wiper switch assembly.



b.
U191333E02
0.99,0.625 1.167,1.073 false 2.292,1.083 2.823,0.708 false 0.146,0.167 0.385,0.417 0.24,0.25 10 false *a 0.292,1.177 0.594,1.354 0.302,0.177 10 false L49 2.906,1.177 3.188,1.344 0.281,0.167 10 false L48 2.854,0.583 3.063,0.75 0.208,0.167 10 false +1 0.792,0.438 1.104,0.604 0.313,0.167 10 false EW

Check the front washer operation.

Text in Illustration
*a Component with harness connected
(Windshield Wiper Switch Assembly)

i.

Connect a voltmeter positive (+) lead to terminal L48-2 (+1) and a negative (-) lead to terminal L49-2 (EW).


ii.

Turn the power switch on (IG).


iii.

Turn the washer switch on and off, and check the voltage between terminals L48-2 (+1) and L49-2 (EW).

OK:

Voltage changes as shown in the illustration.


E353061E04
4.021,1.469 4.104,1.333 false 4.823,1.448 4.74,1.323 false 1.656,0.271 2.844,0.75 1.188,0.479 10 false Washer Switch: 1.021,0.896 2.698,1.333 1.677,0.438 10 false Voltage between terminals L48-2 (+1) and L49-2 (EW): 3.333,0.188 4.302,0.51 0.969,0.323 10 false ON 3.292,0.458 4.26,0.781 0.969,0.323 10 false OFF 2.927,0.833 3.896,1.156 0.969,0.323 10 false 11 to 14 V 3.365,1.135 4.333,1.458 0.969,0.323 10 false 0 V 2.531,1.458 4.396,1.688 1.865,0.229 10 false Approximately 0.5 seconds 4.677,1.458 6.719,1.677 2.042,0.219 10 false Approximately 2.2 seconds

If the result is not as specified, replace the windshield wiper switch assembly.