Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR(for Front Side) › 2012.03–2014.11
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301897 WASHER MOTOR(for Front Side) A

WIPER / WASHER  WASHER MOTOR(for Front Side)  INSTALLATION  


PROCEDURE

Hide 85310 1.INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.

Install the windshield washer motor and pump assembly.


b.
E224720

Connect the connector.


c.

Connect the washer hose.


Hide 2.ADD WASHER FLUID

a.

Add washer fluid to the washer jar.


Hide 53875A 3.INSTALL FRONT FENDER LINER RH

a.

Install new 2 grommets and the 3 screws.


b.

Install the 9 clips.


c.
E223647E02
1.654,2.606 1.841,2.794 0.188,0.188 10 *b 0.76,2.606 0.948,2.794 0.188,0.188 10 *a

Install the pin hold clip as shown in the illustration.

Text in Illustration
*a Correct
*b Incorrect

NOTICE:

Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.



Hide 75850A 4.INSTALL BODY ROCKER PANEL MOULDING ASSEMBLY RH

HINT:

Use the same procedure as for the LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>ROCKER PANEL MOULDING>INSTALLATION).