Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER SWITCH › 2012.03–2014.11
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301903 HEADLIGHT CLEANER SWITCH G

WIPER / WASHER  HEADLIGHT CLEANER SWITCH  INSPECTION  


PROCEDURE

Hide 84150D 1.INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY

E136319E25
0.175,0.107 0.477,0.353 0.302,0.246 10 *a 0.816,1.311 0.965,1.488 0.149,0.177 10 B 1.086,1.847 1.411,2.023 0.325,0.177 10 ILL+ 2.096,1.843 2.394,2.020 0.297,0.177 10 ILL- 2.561,1.294 2.709,1.470 0.149,0.177 10 E 1.597,1.45 1.209,1.837 false 1.841,1.448 2.206,1.814 false 2.029,1.389 2.527,1.389 false 1.411,1.39 0.96,1.39 false

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (E) - 4 (B) Headlight cleaner switch on Below 1 Ω
Headlight cleaner switch off 10 kΩ or higher



b.

Connect a positive (+) lead from the auxiliary battery to terminal 3 (ILL+) and a negative (-) lead to terminal 2 (ILL-).


c.

Check that the headlight cleaner switch assembly illumination comes on.

OK:

The headlight cleaner switch assembly illumination comes on.


Text in Illustration
*a Component without harness connected
(Headlight Cleaner Switch Assembly)

If the result is not as specified, replace the headlight cleaner switch assembly.