Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301907 RAIN SENSOR A

WIPER / WASHER  RAIN SENSOR  INSTALLATION  


PROCEDURE

Hide 89944 1.INSTALL RAIN SENSOR TAPE

HINT:

Rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.


a.

Clean the rain sensor sensing portion with a piece of cloth, etc.


b.
E220066E01
2.137,1.597 2.796,1.597 false 2.82,1.508 2.975,1.654 0.156,0.147 10 *1 1.305,2.93 1.433,3.086 0.128,0.156 10 B 0.544,2.148 0.673,2.304 0.128,0.156 10 A

Peel off the smaller release sheet, and then attach the rain sensor tape on the rain sensor sensing portion as shown in the illustration.

Standard Clearance
Area Measurement
A 13.5 mm (0.532 in.)
B 7.25 mm (0.285 in.)

Text in Illustration
*1 Rain Sensor Tape

NOTICE:

Use your fingers to push out any air bubbles from under the tape.



Hide 89941 2.INSTALL RAIN SENSOR

a.

Clean the windshield glass with a piece of cloth, etc.

NOTICE:
·

Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.

·

If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.




b.

When installing a new rain sensor or replacing the rain sensor tape:

i.

Peel off the release sheet.

HINT:

Do not touch the silicone coated surfaces.




c.
E220065E02
1.219,1.667 0.74,1.552 false 0.552,1.438 0.729,1.594 0.177,0.156 10 false *1 1.25,1.906 1.448,2.094 0.198,0.188 10 false (2) 2.479,1.615 2.677,1.802 0.198,0.188 10 false (1)

Gradually attach the rain sensor to the glass surface to prevent air bubbles from forming between them.

HINT:

Do not touch the silicone coated or glass surfaces.



d.

Push in the stopper.

Text in Illustration
*1 Stopper


e.

Connect the connector.


Hide 89943 3.INSTALL RAIN SENSOR COVER

a.
E250237

Engage the 2 claws and connect the rain sensor cover.


b.

Engage the 2 guides and install the rain sensor cover as shown in the illustration.