Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301907 RAIN SENSOR A

WIPER / WASHER  RAIN SENSOR  REMOVAL  


PROCEDURE

Hide 89943 1.REMOVE RAIN SENSOR COVER

a.
E250236

Disengage the 2 guides and disconnect the rain sensor cover as shown in the illustration.


b.

Disengage the 2 claws and remove the rain sensor cover.


Hide 89941 2.REMOVE RAIN SENSOR

a.
E250238

Disconnect the connector.


b.
E220064E01
1.215,1.661 0.805,1.661 false 0.645,1.575 0.810,1.727 0.165,0.151 10 *1 1.275,1.919 1.463,2.084 0.188,0.165 10 (1) 2.449,1.61 2.638,1.775 0.188,0.165 10 (2)

Release the stopper by pulling the stopper down and disconnect the rain sensor as shown in the illustration.

Text in Illustration
*1 Stopper


Hide 3.CLEAN WINDSHIELD GLASS

HINT:
·

Rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.

·

Check that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue before installing the rain sensor.