Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301907 RAIN SENSOR G

WIPER / WASHER  RAIN SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89941 1.INSPECT RAIN SENSOR

a.
U191229E01
0.289,0.32 0.542,0.525 0.253,0.205 10 *a 1.589,1.474 1.884,1.637 0.295,0.163 10 U12 0.881,1.699 1.108,1.848 0.227,0.149 10 ES 2.455,1.715 2.719,1.868 0.264,0.152 10 SIG 2.046,2.454 2.563,1.911 false 1.59,2.427 1.066,1.86 false

Disconnect the U12 rain sensor connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
U12-2 (ES) - Body ground Always Below 1 Ω


If the result is not as specified, repair or replace the harness or connector.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
U12-4 (SIG) - Body ground Power switch on (IG) 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Rain Sensor)

If the result is not as specified, repair or replace the harness or connector.


d.
U191221E02
1.979,1.927 2.375,1.51 false 1.688,1.385 1.802,1.948 false 0.302,0.24 0.49,0.427 0.188,0.188 10 false *a 2.396,1.323 2.854,1.479 0.458,0.156 10 false MPX 1.552,1.198 1.813,1.354 0.26,0.156 10 false ES 0.667,1.927 0.958,2.083 0.292,0.156 10 false U12

Reconnect the rain sensor connector.


e.

Connect an oscilloscope to the rain sensor connector.


f.

Check for pulses.

OK:
Tester Connection Condition Specified Condition
U12-1 (MPX) - U12-2 (ES) Power switch on (IG) Pulse generation


Text in Illustration
*a Component with harness connected
(Rain Sensor)

If the result is not as specified, the rain sensor may have a malfunction.