The headlight leveling ECU assembly actuates the headlight leveling motor according to vehicle conditions.
Connect the GTS to the DLC3.
Turn the power switch on (READY).
Turn the GTS on.
Enter the following menus: Body Electrical / HL Auto Leveling / Active Test.
Check that the leveling motors operate.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Drive The Leveling Motor UP | Leveling motor upward operation | ON/OFF | ON: Moves up
OFF: Stops |
| Drive The Leveling Motor DOWN | Leveling motor downward operation | ON/OFF | ON: Moves down
OFF: Stops |
Headlight leveling motors operate normally.
OK
NG
Disconnect the A48 headlight leveling ECU assembly connector.
Disconnect the A85 headlight leveling motor LH connector or the A87 headlight leveling motor RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A48-18 (LHT) - A85-7 (LH T) | Always | Below 1 Ω |
| A48-11 (LH+) - A85-8 (LHIG) | Always | Below 1 Ω |
| A48-24 (LH-) - A85-4 (LH E) | Always | Below 1 Ω |
| A48-18 (LHT) - Body ground | Always | 10 kΩ or higher |
| A48-11 (LH+) - Body ground | Always | 10 kΩ or higher |
| A48-24 (LH-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A48-17 (RHT) - A87-7 (RH T) | Always | Below 1 Ω |
| A48-10 (RH+) - A87-8 (RHIG) | Always | Below 1 Ω |
| A48-23 (RH-) - A87-4 (RH E) | Always | Below 1 Ω |
| A48-17 (RHT) - Body ground | Always | 10 kΩ or higher |
| A48-10 (RH+) - Body ground | Always | 10 kΩ or higher |
| A48-23 (RH-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the headlight leveling motor with a new or known good one (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>REMOVAL).
Perform the Active Test of the leveling motors.
Headlight leveling motors operate normally.
OK
NG