This circuit detects the state of the power switch, and sends it to the headlight leveling ECU assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL Auto Leveling / Data List.
Read the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| +B | IG power supply voltage value/0 to 20 V | 11 to 14 V | - |
Normal condition listed above is displayed.
OK
NG
Disconnect the A48 headlight leveling ECU assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A48-1 (IG) - Body ground | Power switch on (IG) | 11 to 14 V |
| A48-1 (IG) - Body ground | Power switch off | Below 1 V |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A48-9 (E1) - Body ground | Always | Below 1 Ω |
OK
NG