Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › from 2014.11
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301908 LIGHTING SYSTEM J

LIGHTING (EXT)  LIGHTING SYSTEM  Headlight Leveling ECU Power Source Circuit  


DESCRIPTION

This circuit detects the state of the power switch, and sends it to the headlight leveling ECU assembly.

WIRING DIAGRAM

E142597E39
4.823,2.708 7,2.896 2.177,0.188 10 false Headlight Leveling ECU Assembly 4.823,2.552 5.104,2.74 0.281,0.188 10 false A48 0.583,1.094 1.948,1.271 1.365,0.177 10 false from IG1 NO. 1 Relay 5.448,1.083 5.646,1.281 0.198,0.198 10 false IG 5.448,2.167 5.646,2.365 0.198,0.198 10 false E1 5.26,2.073 5.365,2.219 0.104,0.146 10 false 9 5.24,0.979 5.365,1.156 0.125,0.177 10 false 1 3.563,1.26 4.104,1.458 0.542,0.198 10 false GAUGE

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / HL Auto Leveling / Data List.


e.

Read the display on the GTS.

HL Auto Leveling
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
+B IG power supply voltage value/0 to 20 V 11 to 14 V -

OK:

Normal condition listed above is displayed.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - HEADLIGHT LEVELING ECU ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - HEADLIGHT LEVELING ECU ASSEMBLY)
a.

Disconnect the A48 headlight leveling ECU assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A48-1 (IG) - Body ground Power switch on (IG) 11 to 14 V
A48-1 (IG) - Body ground Power switch off Below 1 V




OK

3.CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A48-9 (E1) - Body ground Always Below 1 Ω




OK

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR