The headlight beam level control system indicator light in the combination meter sub-assembly comes on for approximately 3 seconds when the power switch is turned on (IG). The indicator light also comes on when the headlight leveling ECU assembly detects a malfunction.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the L27 combination meter sub-assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L27-2 (IG+) - Body ground | Power switch on (IG) | 11 to 14 V |
| Power switch off | Below 1 V |
OK
NG
Disconnect the A48 headlight leveling ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A48-6 (WNG) - L27-27 (LVWG) | Always | Below 1 Ω |
| A48-6 (WNG) - Body ground | Always | 10 kΩ or higher |
OK
NG
Reconnect the L27 combination meter sub-assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L27-27 (LVWG) - Body ground | Power switch on (IG) | 11 to 14 V |
| *a | Component with harness connected
(Combination Meter Sub-assembly) |
OK
NG