The headlight leveling ECU assembly detects the status of the low beam headlights.
First check that the low beam headlights operate normally.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL Auto Leveling / Data List.
Read the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Lo Beam St | Low beam headlight state/ON or OFF | ON: Low beam headlights on
OFF: Low beam headlights off |
- |
Normal conditions listed above are displayed.
OK
NG
Disconnect the A48 headlight leveling ECU assembly connector.
Disconnect the 1G No. 1 integration relay connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A48-3 (HDLP) - 1G-11 (HL4B) | Always | Below 1Ω |
| A48-3 (HDLP) - Body ground | Always | 10 kΩ or higher |
OK
NG