w/o Intelligent Parking Assist System:
The DTC is stored when the headlight leveling ECU assembly detects malfunctions in the rear height control sensor sub-assembly power source or rear height control sensor sub-assembly.
| DTC No. | DTC Detecting Condition | Trouble Area |
|---|---|---|
| B2416 | ·
Malfunction in rear height control sensor sub-assembly ·
Open or short in rear height control sensor sub-assembly power source circuit |
·
Rear height control sensor sub-assembly ·
Harness or connector ·
Headlight leveling ECU assembly |
w/ Intelligent Parking Assist System:
The DTC is stored when the headlight leveling ECU assembly detects malfunctions in the rear height control sensor sub-assembly power source, rear height control sensor sub-assembly or parking assist ECU.
| DTC No. | DTC Detecting Condition | Trouble Area |
|---|---|---|
| B2416 | ·
Malfunction in rear height control sensor sub-assembly ·
Open or short in rear height control sensor sub-assembly power source circuit |
·
Intelligent parking assist system ·
Rear height control sensor sub-assembly ·
Harness or connector ·
Parking assist ECU ·
Headlight leveling ECU assembly |
Clear the DTCs (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR).
DTC B2416 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Check the vehicle condition.
| Result | Proceed to |
|---|---|
| w/o Intelligent Parking Assist System | A |
| w/ Intelligent Parking Assist System | B |
A
B
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL Auto Leveling / Data List.
Read the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Height Sens Pw Supply Val | Rear height control sensor power supply value/0 to 6.25 V | Approximately 5.0 V | - |
Normal condition listed above is displayed.
OK
NG
Connect 3 dry cell batteries (1.5 V) in series.
Remove the rear height control sensor sub-assembly (See page Vehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>REMOVAL).
Connect the positive (+) lead from the batteries to terminal 3 (SHB) and the negative (-) lead from the batteries to terminal 1 (SHG).
Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (SHRR) - 1 (SHG) | +45° (High) | 3.6 to 4.4 V |
| 0° (Normal) | 2.0 to 2.4 V | |
| -35° (Low) | 0.8 to 1.0 V |
| *a | Component without harness connected
(Rear Height Control Sensor Sub-assembly) |
| *b | Low |
| *c | Standard position |
| *d | High |
OK
NG
Disconnect the A48 headlight leveling ECU assembly connector.
Disconnect the S25 rear height control sensor sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A48-12 (SBR) - S25-3 (SHB) | Always | Below 1 Ω |
| A48-21 (SGR) - S25-1 (SHG) | Always | Below 1 Ω |
| A48-12 (SBR) - Body ground | Always | 10 kΩ or higher |
| A48-21 (SGR) - Body ground | Always | 10 kΩ or higher |
OK
NG
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC "C1628 Height Control Sensor Circuit Malfunction" is not output. | OK |
| DTC "C1628 Height Control Sensor Circuit Malfunction" output. | NG |
OK
NG
(See pageAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>C1628)
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL Auto Leveling / Data List.
Read the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Height Sens Pw Supply Val | Rear height control sensor power supply value/0 to 6.25 V | Approximately 5.0 V | - |
Normal condition listed above is displayed.
OK
NG
Disconnect the A48 headlight leveling ECU assembly connector.
Disconnect the L65 parking assist ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A48-12 (SBR) - L65-28 (HB+) | Always | Below 1 Ω |
| A48-21 (SGR) - L65-29 (HGND) | Always | Below 1 Ω |
| A48-12 (SBR) - Body ground | Always | 10 kΩ or higher |
| A48-21 (SGR) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the parking assist ECU with a new or known good one (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST ECU>REMOVAL).
Check for DTCs (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR).
DTC B2416 is not output.
OK
NG