Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › 2014.11–2015.08
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301908 LIGHTING SYSTEM C

LIGHTING (EXT)  LIGHTING SYSTEM  B241A  Rear Height Control Sensor  


DESCRIPTION

w/o Intelligent Parking Assist System:

The headlight leveling ECU assembly receives signals indicating the height of the vehicle from the rear height control sensor sub-assembly.

DTC No. DTC Detecting Condition Trouble Area
B241A
·

Malfunction in rear height control sensor sub-assembly

·

Open or short in rear height control sensor sub-assembly circuit


·

Rear height control sensor sub-assembly

·

Harness or connector

·

Headlight leveling ECU assembly



w/ Intelligent Parking Assist System:

The headlight leveling ECU assembly receives signals regarding the height of the vehicle from the rear height control sensor sub-assembly via the parking assist ECU.

DTC No. DTC Detecting Condition Trouble Area
B241A
·

Malfunction in rear height control sensor sub-assembly

·

Open or short in rear height control sensor sub-assembly circuit


·

Intelligent parking assist system

·

Rear height control sensor sub-assembly

·

Harness or connector

·

Parking assist ECU

·

Headlight leveling ECU assembly



WIRING DIAGRAM

E241419E02
0.378,3.152 1.668,3.312 1.290,0.159 10 Parking Assist ECU 1.067,3.731 1.487,3.882 0.420,0.151 10 SHRR 1.517,0.374 1.696,0.530 0.179,0.156 10 8 5.55,4.205 5.817,4.361 0.267,0.156 10 A48 5.494,0.372 5.730,0.528 0.236,0.156 10 19 5.494,0.769 5.682,0.925 0.188,0.156 10 21 5.494,1.127 5.682,1.283 0.188,0.156 10 12 1.531,4.362 1.654,4.518 0.123,0.156 10 3 1.524,3.99 1.648,4.145 0.123,0.156 10 1 1.542,3.617 1.666,3.773 0.123,0.156 10 2 0.999,0.843 1.433,0.995 0.434,0.151 10 HGND 1.119,1.267 1.434,1.418 0.315,0.151 10 HB+ 1.106,0.463 1.434,0.614 0.328,0.151 10 HO1 0.378,2.978 0.691,3.134 0.313,0.156 10 L65 1.156,4.106 1.488,4.258 0.332,0.151 10 SHG 1.517,0.761 1.705,0.917 0.188,0.156 10 29 1.174,4.443 1.488,4.594 0.313,0.151 10 SHB 5.742,0.48 6.143,0.632 0.401,0.151 10 SHRL 5.729,0.879 6.112,1.030 0.383,0.151 10 SGR 5.737,1.265 6.106,1.416 0.369,0.151 10 SBR 1.517,1.162 1.705,1.318 0.188,0.156 10 28 1.517,1.514 1.696,1.670 0.179,0.156 10 27 1.121,2.403 1.425,2.554 0.304,0.151 10 HG1 1.199,2.785 1.440,2.936 0.241,0.151 10 HI1 1.04,1.602 1.436,1.753 0.396,0.151 10 HBL+ 1.517,1.906 1.724,2.062 0.207,0.156 10 30 1.04,1.994 1.471,2.146 0.430,0.151 10 HBE+ 1.517,2.321 1.705,2.476 0.188,0.156 10 31 1.517,2.694 1.705,2.850 0.188,0.156 10 9 4.022,2.803 4.298,2.973 0.276,0.170 10 *2 4.405,2.803 4.681,2.973 0.276,0.170 10 *2 4.779,2.803 5.055,2.973 0.276,0.170 10 *2 2.557,0.568 2.856,0.738 0.299,0.170 10 *1 2.557,0.965 2.856,1.135 0.299,0.170 10 *1 2.557,1.348 2.856,1.518 0.299,0.170 10 *1 1.894,3.16 2.101,3.330 0.207,0.170 10 *1 2.258,3.16 2.465,3.330 0.207,0.170 10 *1 2.674,3.09 2.880,3.260 0.207,0.170 10 *1 3.094,3.09 3.301,3.260 0.207,0.170 10 *1 2.674,3.258 2.880,3.428 0.207,0.170 10 *4 3.094,3.258 3.301,3.428 0.207,0.170 10 *3 5.55,4.373 6.791,4.730 1.241,0.356 10 Headlight Leveling ECU Assembly 0.427,4.497 0.736,4.648 0.309,0.151 10 S25 0.427,4.661 3.125,4.853 2.698,0.192 10 Rear Height Control Sensor Sub-assembly 0.245,5.121 2.749,5.296 2.504,0.174 10 *1: w/ Intelligent Parking Assist System 2.888,5.121 5.458,5.296 2.569,0.174 10 *2: w/o Intelligent Parking Assist System 0.245,5.43 1.161,5.604 0.916,0.174 10 *3: LED Type 2.888,5.43 4.291,5.604 1.402,0.174 10 *4: except LED Type

PROCEDURE

1.CHECK FOR DTC

b.

Check for DTCs (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B241A is not output.




OK

NG

2.CHECK VEHICLE CONDITION
2.CHECK VEHICLE CONDITION
a.

Check the vehicle condition.

Result:
Result Proceed to
w/o Intelligent Parking Assist System A
w/ Intelligent Parking Assist System B




A

3.READ VALUE USING GTS

B

6.CHECK FOR DTC (INTELLIGENT PARKING ASSIST SYSTEM)
3.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / HL Auto Leveling / Data List.


e.

Read the display on the GTS.

HL Auto Leveling
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Height Sens Pw Supply Val Rear height control sensor power supply value / 0 to 6.25 V Approximately 5.0 V -
Rr Height Sens Signal Val Rear height control sensor signal value / 0 to 5 V Approximately 2.5 V (When the vehicle is level) Value is changed according to vehicle height

OK:

Normal conditions listed above are displayed.




OK

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY

NG

4.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
4.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
a.

Connect 3 dry cell batteries (1.5 V) in series.

E361814E01
6.031,1.521 6.26,1.094 false 5.865,1.51 6.177,0.802 false 5.719,1.521 5.094,0.771 false 2.146,0.24 2.458,0.438 0.313,0.198 10 false *b 2.458,0.667 2.771,0.865 0.313,0.198 10 false -35° 2.802,1.135 3.115,1.333 0.313,0.198 10 false *c 2.646,1.906 3.063,2.156 0.417,0.25 10 false +45° 2.417,2.479 2.729,2.677 0.313,0.198 10 false *d 1.719,0.979 2.198,1.208 0.479,0.229 10 false -11.9° 4.729,0.667 5.135,0.875 0.406,0.208 10 false SHB 3.927,0.271 4.24,0.469 0.313,0.198 10 false *a 6.219,0.667 6.698,0.875 0.479,0.208 10 false SHRR 6.313,1.01 6.719,1.219 0.406,0.208 10 false SHG


b.

Remove the rear height control sensor sub-assembly (See page Vehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>REMOVAL).


c.

Connect the positive (+) lead from the batteries to terminal 3 (SHB) and the negative (-) lead from the batteries to terminal 1 (SHG).


d.

Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (SHRR) - 1 (SHG) +45° (High) 3.6 to 4.4 V
0° (Normal) 2.0 to 2.4 V
-35° (Low) 0.8 to 1.0 V


Text in Illustration
*a Component without harness connected
(Rear Height Control Sensor Sub-assembly)
*b Low
*c Standard position
*d High



OK

5.CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU ASSEMBLY - HEIGHT CONTROL SENSOR)

NG

REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

5.CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU ASSEMBLY - HEIGHT CONTROL SENSOR)
a.

Disconnect the A48 headlight leveling ECU assembly connector.


b.

Disconnect the S25 rear height control sensor sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A48-19 (SHRL) - S25-2 (SHRR) Always Below 1 Ω
A48-19 (SHRL) - Body ground Always 10 kΩ or higher




OK

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK FOR DTC (INTELLIGENT PARKING ASSIST SYSTEM)
a.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC "C1628 Height Control Sensor Circuit Malfunction" is not output. OK
DTC "C1628 Height Control Sensor Circuit Malfunction" output. NG




OK

7.READ VALUE USING GTS

NG

7.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / HL Auto Leveling / Data List.


e.

Read the display on the GTS.

HL Auto Leveling
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Height Sens Pw Supply Val Rear height control sensor power supply value/0 to 6.25 V Approximately 5.0 V -
Rr Height Sens Signal Val Rear height control sensor signal value/0 to 5 V Approximately 2.5 V (When the vehicle is level) Value is changed according to vehicle height

OK:

Normal conditions listed above are displayed.




OK

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY

NG

8.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - HEADLIGHT LEVELING ECU ASSEMBLY)
8.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - HEADLIGHT LEVELING ECU ASSEMBLY)
a.

Disconnect the A48 headlight leveling ECU assembly connector.


b.

Disconnect the L65 parking assist ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A48-19 (SHRL) - L65-8 (HO1) Always Below 1 Ω
A48-19 (SHRL) - Body ground Always 10 kΩ or higher




OK

9.CHECK PARKING ASSIST ECU

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

9.CHECK PARKING ASSIST ECU
a.

Replace the parking assist ECU with a new or known good one (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST ECU>REMOVAL).


b.

Check for DTCs (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B241A is not output.




OK

END (PARKING ASSIST ECU WAS DEFECTIVE)

NG

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY