Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY › 2012.03–2014.11
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301909 HEADLIGHT ASSEMBLY A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY  REPAIR  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

If the installation area of the headlight assembly is damaged, use the supply retainer for low-cost repair.

·

Ensure that the headlight assembly is not damaged.



PROCEDURE

Hide 81194 1.INSTALL UPPER HEADLIGHT PROTECTOR RETAINER

a.
E228268

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E228269

Install the upper headlight protector retainer with the 2 screws.


Hide 81194B 2.INSTALL UPPER NO. 2 HEADLIGHT PROTECTOR RETAINER

a.
E228270

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E228271

Install the upper No. 2 headlight protector retainer with the 2 screws.


Hide 81194D 3.REMOVE UPPER HEADLIGHT PROTECTOR RETAINER LH

a.
E253902

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper headlight protector retainer LH against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E253903

Install the upper headlight protector retainer LH with the 2 screws.


Hide 81196A 4.INSTALL LOWER HEADLIGHT PROTECTOR RETAINER

a.
E228272

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E228273

Install the lower headlight protector retainer with the 2 screws.


Hide 81196D 5.INSTALL LOWER NO. 2 HEADLIGHT PROTECTOR RETAINER

a.
E227599

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E227600

Install the lower No. 2 headlight protector retainer with the 2 screws.