1.INSPECT REAR COMBINATION LIGHT ASSEMBLY LH
Remove the rear combination light assembly LH.
| *a | Component without harness connected
(Rear Combination Light Assembly LH) |
Apply battery voltage to the rear combination light assembly LH and check that the lights come on.
| Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 4 (B)
Auxiliary battery negative (-) → Terminal 5 (E) |
Stop light comes on |
| Auxiliary battery positive (+) → Terminal 2 (B)
Auxiliary battery negative (-) → Terminal 5 (E) |
Taillight comes on |
| Auxiliary battery positive (+) → Terminal 6 (B)
Auxiliary battery negative (-) → Terminal 5 (E) |
Turn signal light comes on |
If the result is not as specified, repair or replace the rear combination light socket and wire sub-assembly LH.
2.INSPECT REAR COMBINATION LIGHT ASSEMBLY RH
Remove the rear combination light assembly RH.
| *a | Component without harness connected
(Rear Combination Light Assembly RH) |
Apply battery voltage to the rear combination light assembly RH and check that the lights come on.
| Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 4 (B)
Auxiliary battery negative (-) → Terminal 5 (E) |
Stop light comes on |
| Auxiliary battery positive (+) → Terminal 2 (B)
Auxiliary battery negative (-) → Terminal 5 (E) |
Taillight comes on |
| Auxiliary battery positive (+) → Terminal 6 (B)
Auxiliary battery negative (-) → Terminal 5 (E) |
Turn signal light comes on |
If the result is not as specified, repair or replace the rear combination light socket and wire sub-assembly RH.