Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301912 REAR COMBINATION LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  DISASSEMBLY  


PROCEDURE

Hide 81564 1.REMOVE REAR COMBINATION LIGHT BODY GASKET

a.
E222930

Remove the 2 rear combination light body gaskets.

NOTICE:
·

Be sure to remove all the traces of the old gaskets from the body.

·

Do not reuse the removed gaskets. Be sure to install new rear combination light body gaskets to prevent water ingress.




Hide 81562A 2.REMOVE REAR COMBINATION LIGHT GASKET

a.
E222931

Remove the rear combination light gasket.

NOTICE:
·

Be sure to remove all the traces of the old gasket from the body.

·

Do not reuse the removed gasket. Be sure to install a new rear combination light gasket to prevent water ingress.




Hide 81550L 3.REMOVE REAR TURN SIGNAL LIGHT BULB

a.
E222932

Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration, and disconnect them as a unit.


b.

Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.


Hide 81550Q 4.REMOVE REAR NO. 1 FOG LIGHT BULB (for LH Side)

a.
E222934

Turn the rear combination light socket and wire sub-assembly with the rear No. 1 fog light blub in the direction indicated by the arrow shown in the illustration, and disconnect them as a unit.


b.

Remove the rear No. 1 fog light blub from the rear combination light socket and wire sub-assembly.


Hide 81550N 5.REMOVE BACK-UP LIGHT BULB (for RH Side)

a.
E222936

Turn the rear combination light socket and wire sub-assembly with the back-up light bulb in the direction indicated by the arrow shown in the illustration, and disconnect them as a unit.


b.

Remove the back-up light bulb from the rear combination light socket and wire sub-assembly.


Hide 81565 6.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY

a.
E222938

Disconnect the connector.


b.

Disengage the claw and remove the rear combination light socket and wire sub-assembly.