Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
1.REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
81270
2.REMOVE LICENSE PLATE LIGHT ASSEMBLY
Disconnect the connector.
Disengage the 2 claws and remove the license plate light assembly.
81270B
3.REMOVE LICENSE PLATE LIGHT BULB
Turn the license plate light socket plug with the license plate light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.
Remove the license plate light bulb from the license plate light socket plug.