Home › Vehicle Exterior › LIGHTING (EXT) › HIGH MOUNTED STOP LIGHT ASSEMBLY
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301914 HIGH MOUNTED STOP LIGHT ASSEMBLY G

LIGHTING (EXT)  HIGH MOUNTED STOP LIGHT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT CENTER STOP LIGHT ASSEMBLY

a.
E297633E03
1.052,1.573 1.531,1.177 false 2.302,1.604 1.823,1.188 false 0.135,0.115 0.448,0.313 0.313,0.198 12 false *a 0.938,1.563 1.396,1.76 0.458,0.198 10 false B 2.323,1.604 2.781,1.802 0.458,0.198 10 false E

Connect a positive (+) lead from the battery to terminal 2 (B) and a negative (-) lead to terminal 1 (E).


b.

Check that the center stop light comes on.

OK:

The light comes on.


Text in Illustration
*a Component without harness connected
(Center Stop Light Assembly)

If the result is not as specified, replace the center stop light assembly.


Hide 2.REMOVE CENTER STOP LIGHT WIRE HARNESS

a.
E298158E03
0.131,0.043 0.287,0.224 0.156,0.181 10 *a 0.496,0.278 0.807,0.459 0.310,0.181 10 WT1 2.347,0.335 2.572,0.516 0.225,0.181 10 W1 0.456,0.253 0.897,0.465 0.441,0.212 2.284,0.328 2.645,0.522 0.361,0.195 0.64,1.284 0.405,1.645 false 0.852,1.29 1.041,1.657 false 2.301,1.279 2.06,1.599 false 2.759,1.284 2.954,1.571 false 0.284,1.67 0.471,1.851 0.187,0.181 10 E2 0.972,1.67 1.259,1.851 0.287,0.181 10 LED 1.917,1.595 2.073,1.776 0.156,0.181 10 E 2.96,1.567 3.116,1.748 0.156,0.181 10 B

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
WT1-1 (E2) - W1-1 (E) Always Below 1 Ω
WT1-1 (E2) - W1-2 (B) Always 10 kΩ or higher
WT1-2 (LED) - W1-2 (B) Always Below 1 Ω
WT1-2 (LED) - W1-1 (E) Always 10 kΩ or higher

Text in Illustration
*a Component without harness connected
(Center Stop Light Wire Harness)

If the result is not as specified, replace the center stop light set.