Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH › 2013.08–2014.11
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301916 HAZARD WARNING SWITCH A

LIGHTING (EXT)  HAZARD WARNING SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 84330 9.REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

a.
E228283

Using a screwdriver, disengage the 4 claws and remove the hazard warning signal switch assembly.