Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301918 AUTOMATIC LIGHT CONTROL SENSOR G

LIGHTING (EXT)  AUTOMATIC LIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89120A 1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR

a.
U154517E01
0.079,0.051 0.301,0.243 0.222,0.193 10 *a 0.955,1.325 1.153,1.474 0.198,0.149 10 I1 0.964,1.897 1.336,2.046 0.372,0.149 10 CLTB 2.285,1.607 2.663,1.756 0.378,0.149 10 CLTE 1.906,1.665 2.257,1.665 false 1.558,1.495 1.224,1.89 false

Disconnect the I1 automatic light control sensor connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I1-3 (CLTB) - I1-6 (CLTE) Power switch off Below 1 V
Power switch on (IG) 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
I1-6 (CLTE) - Body ground Always Below 1 Ω


Text in Illustration
*a Front view of wire harness connector
(to Automatic Light Control Sensor)

If the result is not as specified, there may be a malfunction on the wire harness side.


c.
U155042E01
0.163,0.118 0.365,0.274 0.202,0.156 10 *a 0.484,2.499 0.874,2.643 0.390,0.144 10 CLTS 1.026,2.923 1.411,3.067 0.385,0.144 10 CLTE 1.588,2.391 1.259,2.883 false 1.588,2.258 0.977,2.565 false 0.521,1.653 0.680,1.843 0.158,0.190 10 I1

Reconnect the I1 automatic light control sensor connector.


d.

Connect an oscilloscope to the automatic light control sensor connector.

Text in Illustration
*a Component with harness connected
(Automatic Light Control Sensor)


e.
B113714E30
2.948,1.063 3.292,1.219 0.344,0.156 10 GND 1.844,1.177 1.969,1.333 0.125,0.156 10 A

Check the waveform.

OK:
Tester Connection Tool Setting Condition Specified Condition
I1-6 (CLTE) - I1-4 (CLTS) 5 V/DIV., 5 ms./DIV Power switch on (IG), light control switch in AUTO position Correct waveform is as shown


HINT:

If the ambient light becomes brighter, width A becomes narrower.


If the result is not as specified, the automatic light control sensor may have a malfunction.