Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301919 HEIGHT CONTROL SENSOR G

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89407A 1.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

a.

Connect 3 dry cell batteries (1.5 V) in series.

E361814E01
6.031,1.521 6.26,1.094 false 5.865,1.51 6.177,0.802 false 5.719,1.521 5.094,0.771 false 2.146,0.24 2.458,0.438 0.313,0.198 10 false *b 2.458,0.667 2.771,0.865 0.313,0.198 10 false -35° 2.802,1.135 3.115,1.333 0.313,0.198 10 false *c 2.646,1.906 3.063,2.156 0.417,0.25 10 false +45° 2.417,2.479 2.729,2.677 0.313,0.198 10 false *d 1.719,0.979 2.198,1.208 0.479,0.229 10 false -11.9° 4.729,0.667 5.135,0.875 0.406,0.208 10 false SHB 3.927,0.271 4.24,0.469 0.313,0.198 10 false *a 6.219,0.667 6.698,0.875 0.479,0.208 10 false SHRR 6.313,1.01 6.719,1.219 0.406,0.208 10 false SHG


b.

Connect the positive (+) lead from the batteries to terminal 3 (SHB) and the negative (-) lead from the batteries to terminal 1 (SHG).


c.

Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (SHRR) - 1 (SHG) +45° (High) 3.6 to 4.4 V
2 (SHRR) - 1 (SHG) 0° (Normal) 2.0 to 2.4 V
2 (SHRR) - 1 (SHG) -35° (Low) 0.8 to 1.0 V


Text in Illustration
*a Component with harness connected
(Rear Height Control Sensor Sub-assembly)
*b Low
*c Standard position
*d High

If the result is not as specified, replace the rear height control sensor sub-assembly.