Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR › 2012.03–2013.08
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301919 HEIGHT CONTROL SENSOR A

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 8.REMOVE REAR WHEEL

Hide 89407A 9.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

a.
E222948

Disconnect the connector.


b.

Remove the 3 bolts.


c.

Disengage the guide and remove the rear height control sensor sub-assembly.

NOTICE:

Do not drop the rear height control sensor sub-assembly. If it is dropped, replace it with a new one.