Home › Vehicle Exterior › LIGHTING (EXT) › RELAY › 2012.03–2014.11
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301922 RELAY G

LIGHTING (EXT)  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85926 1.INSPECT DIM RELAY

a.
E209495

Remove the DIM relay from the engine room relay block and junction block assembly.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the DIM relay.


Hide 82642A 2.INSPECT DRL RELAY

a.
B416269E03
1.729,0.719 2,0.719 false 2.656,0.719 2.927,0.719 false 2.521,1.125 2.938,1.125 false 2.531,1.625 2.948,1.625 false 1.208,1.313 1.385,1.542 0.177,0.229 10 false 1 1.219,0.76 1.396,0.99 0.177,0.229 10 false 5 0.208,0.771 0.385,1 0.177,0.229 10 false 3 0.208,1.323 0.385,1.552 0.177,0.229 10 false 2 1.604,0.646 1.781,0.875 0.177,0.229 10 false 1 2.979,0.635 3.156,0.865 0.177,0.229 10 false 2 3,1.042 3.177,1.271 0.177,0.229 10 false 5 3,1.542 3.177,1.771 0.177,0.229 10 false 3

Remove the DRL relay from the engine room relay block and junction block assembly.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the DRL relay.


Hide 85916L 3.INSPECT REAR FOG LIGHT RELAY

a.
B416269E03
1.729,0.719 2,0.719 false 2.656,0.719 2.927,0.719 false 2.521,1.125 2.938,1.125 false 2.531,1.625 2.948,1.625 false 1.208,1.313 1.385,1.542 0.177,0.229 10 false 1 1.219,0.76 1.396,0.99 0.177,0.229 10 false 5 0.208,0.771 0.385,1 0.177,0.229 10 false 3 0.208,1.323 0.385,1.552 0.177,0.229 10 false 2 1.604,0.646 1.781,0.875 0.177,0.229 10 false 1 2.979,0.635 3.156,0.865 0.177,0.229 10 false 2 3,1.042 3.177,1.271 0.177,0.229 10 false 5 3,1.542 3.177,1.771 0.177,0.229 10 false 3

Remove the rear fog light relay.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the rear fog light relay.