Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING SWITCH
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301924 HEADLIGHT LEVELING SWITCH G

LIGHTING (EXT)  HEADLIGHT LEVELING SWITCH  INSPECTION  


PROCEDURE

Hide 84152 1.INSPECT HEADLIGHT LEVELING SWITCH

a.
E133257E11
0.182,0.106 0.382,0.302 0.200,0.196 10 *a

Connect a (+) lead from the battery to terminal 1 and a (-) lead to terminal 4.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Position Specified Condition
(Battery voltage is 12 V)
2 - 1 0 9.48 to 10.2 V
(0.5) 8.77 to 9.49 V
1 8.06 to 8.78 V
(1.5) 7.36 to 8.08 V
2 6.65 to 7.37 V
(2.5) 5.94 to 6.66 V
3 5.23 to 5.95 V
(3.5) 4.52 to 5.24 V
4 3.82 to 4.54 V
(4.5) 3.1 to 3.83 V
5 2.4 to 3.12 V


If the result is not as specified, replace the headlight leveling switch.


c.

Connect a (+) lead from the battery to terminal 3 and a (-) lead to terminal 4.


d.

Check that the illumination of the switch comes on.

OK:

The illumination comes on.


Text in Illustration
*a Component without harness connected
(Headlight Leveling Switch)

If the result is not as specified, replace the headlight leveling switch.