Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM MAIN SWITCH › from 2014.11
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301926 AUTOMATIC HIGH BEAM MAIN SWITCH G

LIGHTING (EXT)  AUTOMATIC HIGH BEAM MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84010D 1.INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (AUTO HIGH BEAM SWITCH)

a.
B388839E01
0.256,0.098 0.628,0.337 0.371,0.239 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
7 - 2 Auto high beam switch not pushed (OFF) 10 kΩ or higher
Auto high beam switch pushed (ON) Below 1 Ω


Text in Illustration
*a Component without harness connected
(Auto High Beam Switch)


b.

Check the switch illumination and indicator.

i.

Apply auxiliary battery voltage to the auto high beam switch and check that the switch illumination and each indicator come on.

OK:
Battery Connection Specified Condition
Auxiliary Battery positive (+) → 4
Auxiliary Battery positive (-) → 1
Switch illumination comes on