Home › Vehicle Exterior › HORN › RELAY › from 2014.11
RM2070E _59 Vehicle Exterior _061954 HORN _0301929 RELAY G

HORN  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 86530 1.INSPECT HORN RELAY

a.
E226254E28
2.885,0.781 3.167,0.781 false 3.167,1.115 2.771,1.115 false 2.021,0.792 2.313,0.792 false 3.167,1.563 2.771,1.563 false 1.896,0.688 2.135,0.958 0.24,0.271 10 false 1 3.24,0.667 3.427,0.885 0.188,0.219 10 false 2 3.24,1 3.427,1.26 0.188,0.26 10 false 5 3.229,1.458 3.427,1.74 0.198,0.281 10 false 3 0.115,0.146 0.354,0.417 0.24,0.271 10 false *a

Remove the HORN relay.

Text in Illustration
*a Component without harness connected
(HORN Relay)


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher
3 - 5 Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the HORN relay.