53289A
1.REMOVE RADIATOR SUPPORT OPENING COVER
Remove the 3 clips.
Disengage the 3 guides and remove the radiator support opening cover.
2.REMOVE FRONT BUMPER ASSEMBLY
Put protective tape around the front bumper assembly.
| *1 | Protective Tape |
Use the same procedure for the RH side and LH side.
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
| *a | 90° |
Use the same procedure for the RH side and LH side.
Remove the screw.
Use the same procedure for the RH side and LH side.
Remove the 6 screws.
Using a clip remover, remove the 3 clips.
Remove the 4 bolts.
Disengage the 3 claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
Disconnect each connector.
w/ Headlight Cleaner System:
Disconnect the headlight cleaner hose and drain the washer fluid.
Use a container to collect the washer fluid.
Remove the front bumper assembly as shown in the illustration.