53289A
1.REMOVE RADIATOR SUPPORT OPENING COVER
Remove the 3 clips.
Disengage the 3 guides and remove the radiator support opening cover.
2.REMOVE FRONT BUMPER ASSEMBLY
Apply protective tape around the front bumper assembly as shown in the illustration.
|
Protective Tape |
Remove the screw.
Use the same procedure for the RH side and LH side.
Remove the 6 screws.
Using a clip remover, remove the 3 clips.
Remove the 4 bolts.
Disengage the 2 claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
Disconnect each connector.
Remove the front bumper assembly as shown in the illustration.