52016A
1.INSTALL REAR BUMPER ARM SUB-ASSEMBLY LH
Install the rear bumper arm sub-assembly LH with the 3 bolts.
52015A
2.INSTALL REAR BUMPER ARM SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
52171A
3.INSTALL NO. 1 REAR BUMPER REINFORCEMENT
Install the No. 1 rear bumper reinforcement with the 8 bolts.
52576
4.INSTALL REAR BUMPER SIDE RETAINER LH
Engage the 2 claws to install the rear bumper side retainer LH.
Install the screw.
52575
5.INSTALL REAR BUMPER SIDE RETAINER RH
Use the same procedure as for the LH side.
52156A
6.INSTALL REAR BUMPER SIDE SUPPORT LH
Engage the 4 claws.
Install the rear bumper side support LH with the 2 screws.
52155A
7.INSTALL REAR BUMPER SIDE SUPPORT RH
Use the same procedure as for the LH side.
81920
8.INSTALL REFLEX REFLECTOR ASSEMBLY LH
Engage the 2 claws.
Install the reflex reflector assembly LH with the screw.
81910
9.INSTALL REFLEX REFLECTOR ASSEMBLY RH
Use the same procedure as for the LH side.
76872A
10.INSTALL REAR NO. 1 SPOILER PROTECTOR
Clean the rear No. 1 spoiler.
Remove any remaining double-sided tape from the rear No. 1 spoiler.
Wipe off any tape adhesive residue with cleaner.
Remove the release paper from a new rear No. 1 spoiler protector.
After removing the release paper, keep the exposed adhesive free from foreign matter.
Install the rear No. 1 spoiler protector as shown in the illustration.
| *a | Line |
Install the rear No. 1 spoiler protector along the line marked on the rear No. 1 spoiler.
76891
11.INSTALL REAR NO. 1 SPOILER
Engage the 13 guides.
Install the 13 outside moulding retainers.
Install the rear No. 1 spoiler with the 10 clips.