When removing name plates or emblems, heat the vehicle body and name plates using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Name Plate or Emblem | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body, name plates or emblems excessively.
75431A
1.REMOVE NO. 1 BACK DOOR EMBLEM
Remove the back door outside garnish sub-assembly (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>BACK DOOR OUTSIDE GARNISH>REMOVAL).
Disengage the 3 claws and pin, and remove the No. 1 back door emblem.
75442A
2.REMOVE NO. 2 BACK DOOR NAME PLATE
Put protective tape around the No. 2 back door name plate.
| *A | Type A |
| *B | Type B |
| *1 | Protective Tape |
Using a moulding remover, peel off the double-sided tape to remove the No. 2 back door name plate.
If reusing the name plate, take care not to damage the No. 2 back door name plate.
Be careful not to damage the vehicle body.
75441E
3.REMOVE NO. 1 BACK DOOR NAME PLATE
for TOYOTA Plate:
Put protective tape around the No. 1 back door name plate.
| *1 | Protective Tape |
Using a moulding remover, peel off the double-sided tape to remove the No. 1 back door name plate.
If reusing the emblems, take care not to damage the No. 1 back door name plate.
Be careful not to damage the vehicle body.
for Hybrid Plate:
Put protective tape around the No. 1 back door name plate.
| *A | Type A |
| *B | Type B |
| *1 | Protective Tape |
Using a moulding remover, peel off the double-sided tape to remove the No. 1 back door name plate.
If reusing the emblems, take care not to damage the No. 1 back door name plate.
Be careful not to damage the vehicle body.
75374
4.REMOVE SIDE PANEL EMBLEM
Put protective tape around the side panel emblem.
| *1 | Protective Tape |
Using a moulding remover, peel off the double-sided tape and disengage the 2 pins to remove the side panel emblem.
If reusing the name plate, take care not to damage the side panel emblem.
Be careful not to damage the vehicle body.
Use the same procedure for the RH side and LH side.