Perform the following procedure only if the windshield outside sub moulding will be replaced with a new one without removing the windshield glass.
75549A
1.REMOVE WINDSHIELD OUTSIDE SUB MOULDING
Cut off both ends of the windshield outside sub moulding at the locations shown in the illustration.
| *1 | Roof Window Upper Moulding |
| *a | Cut Position |
| Area | Dimension |
|---|---|
| a | 11.0 mm (0.433 in.) |
Do not damage the roof window upper moulding.
Use the same procedure for the RH side and LH side.
Cut the windshield outside sub moulding in the order shown in the illustration, to remove the windshield outside sub moulding.
| *1 | Windshield Glass | *2 | Roof Window Glass |
| *a | Cut Position | - | - |
After cutting off the parts of the windshield outside sub moulding shown in the illustration above, do not remove the remaining windshield outside sub moulding from the windshield glass.