1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58410B
2.REMOVE DECK BOARD ASSEMBLY
58411A
3.REMOVE NO. 1 DECK BOARD
58412A
4.REMOVE NO. 2 DECK BOARD
64993
5.REMOVE REAR DECK FLOOR BOX
64995
6.REMOVE DECK FLOOR BOX RH
7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
69284C
8.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
9.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
10.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
74222
11.REMOVE DOOR ARMREST COVER
67602
12.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
67626
13.REMOVE FRONT DOOR TRIM BRACKET
67832
14.REMOVE FRONT DOOR SERVICE HOLE COVER
68102
15.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
68151D
16.REMOVE FRONT DOOR GLASS RUN
75720
17.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY
75756C
18.REMOVE FRONT DOOR REAR WINDOW FRAME MOULDING
67664C
19.REMOVE DOOR FRAME GARNISH
67862
20.DISCONNECT FRONT DOOR WEATHERSTRIP
Using a clip remover, disengage the 2 clips and remove the upper part of the front door weatherstrip to the extent that allows removal of the front door strip and black out tape.
75922M
21.REMOVE NO. 1 BLACK OUT TAPE
Using a heat light, heat the No. 1 black out tape and vehicle body.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
Do not heat the vehicle body excessively.
Pull back on one of the ends of the No. 1 black out tape to remove it.
When pulling on the tape, pull it parallel to the body.
75986B
22.REMOVE FRONT DOOR STRIPE
Using a heat light, heat the front door stripe and vehicle body.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
Do not heat the vehicle body excessively.
Pull back on one of the ends of the front door stripe to remove it.
When pulling on the stripe, pull it parallel to the body.
75976G
23.REMOVE FRONT DOOR LOWER OUTSIDE STRIPE
Using a heat light, heat the front door lower outside stripe and vehicle body.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
Do not heat the vehicle body excessively.
Pull back on one of the ends of the front door lower outside stripe to remove it.
When pulling on the stripe, pull it parallel to the body.
75966B
24.REMOVE FRONT DOOR REAR OUTSIDE STRIPE
Using a heat light, heat the front door rear outside stripe and vehicle body.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
Do not heat the vehicle body excessively.
Pull back on one of the ends of the front door rear outside stripe to remove it.
When pulling on the stripe, pull it parallel to the body.