Home › Vehicle Exterior › VEHICLE PROXIMITY NOTIFICATION SYSTEM › VEHICLE PROXIMITY NOTIFICATION SYSTEM › 2015.08–2020.08
RM2070E _59 Vehicle Exterior _061962 VEHICLE PROXIMITY NOTIFICATION SYSTEM _0301952 VEHICLE PROXIMITY NOTIFICATION SYSTEM J

VEHICLE PROXIMITY NOTIFICATION SYSTEM  VEHICLE PROXIMITY NOTIFICATION SYSTEM  Sound does not Turn ON or OFF when the Vehicle Approaching Speaker Switch is Pressed  


DESCRIPTION

When the vehicle approaching speaker switch is pushed when the vehicle approaching speaker system is on, the vehicle approaching speaker controller receives a signal to temporarily suspend output of the warning sound from the vehicle approaching speaker assembly.

WIRING DIAGRAM

E330647E12
1.49,0.75 2.469,1.125 0.979,0.375 10 false from IG1 NO. 1 Relay 2.646,0.885 3.688,1.167 1.042,0.281 10 false ECU-IG NO. 2 1.354,1.542 4.01,1.771 2.656,0.229 10 false Instrument Panel Junction Block Assembly 1.344,1.396 1.719,1.677 0.375,0.281 10 false 2B 1.344,3 1.719,3.281 0.375,0.281 10 false A68 1.344,3.177 3.781,3.448 2.438,0.271 10 false Vehicle Approaching Speaker Switch 4.813,3 5.188,3.281 0.375,0.281 10 false L130 4.823,3.188 6.177,3.708 1.354,0.521 10 false Vehicle Approaching Speaker Controller 2.917,2.5 3.292,2.781 0.375,0.281 10 false ECU 3.052,2.125 3.427,2.406 0.375,0.281 10 false IG 3.281,2.135 3.656,2.417 0.375,0.281 10 false 8 3.292,2.49 3.667,2.771 0.375,0.281 10 false 11 3.74,0.656 4.115,0.938 0.375,0.281 10 false 16 4.854,0.656 5.229,0.938 0.375,0.281 10 false 1 5.031,0.76 5.406,1.042 0.375,0.281 10 false IG 5.021,2.604 5.396,2.885 0.375,0.281 10 false SW 4.854,2.5 5.229,2.781 0.375,0.281 10 false 5

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.READ VALUE USING GTS (Operation Cancel SW)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Data List.


e.

Read the Data List according to the display on the GTS.

Vehicle Proximity Notification System
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Operation Cancel SW Vehicle approaching speaker switch / OFF or ON OFF: Vehicle approaching speaker switch not pressed
ON: Vehicle approaching speaker switch pressed
-

Result:
Result Proceed to
The GTS display changes according to the operation of the vehicle approaching speaker switch but the warning sound does not stop A
The GTS display changes according to the operation of the vehicle approaching speaker switch but the warning sound does not start B
The GTS display does not change according to the operation of the vehicle approaching speaker switch C




A

B

C

2.INSPECT VEHICLE APPROACHING SPEAKER SWITCH
2.INSPECT VEHICLE APPROACHING SPEAKER SWITCH
a.

Remove the vehicle approaching speaker switch (See page Vehicle Exterior>VEHICLE PROXIMITY NOTIFICATION SYSTEM>VEHICLE APPROACHING SPEAKER>REMOVAL).


b.


OK

3.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER SWITCH - IG1 NO. 1 RELAY)

NG

3.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER SWITCH - IG1 NO. 1 RELAY)
a.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A68-8 (IG) - Body ground Power switch on (IG) 11 to 14 V
Power switch off Below 1 V




OK

4.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER CONTROLLER - VEHICLE APPROACHING SPEAKER SWITCH)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER CONTROLLER - VEHICLE APPROACHING SPEAKER SWITCH)
a.

Disconnect the L130 vehicle approaching speaker controller connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L130-5 (SW) - A68-11 (ECU) Always Below 1 Ω
L130-5 (SW) or A68-11 (ECU) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR