The vehicle approaching speaker controller communicates with the GTS through the DLC3.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
The vehicle approaching speaker controller and GTS communicate using SIL communication.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Health Check.
| Result | Proceed to |
|---|---|
| Communication with the vehicle approaching speaker controller is not possible | A |
| Communication with the vehicle approaching speaker controller is possible | B |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
Disconnect the L130 vehicle approaching speaker controller connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L130-1 (IG) - Body ground | Power switch on (IG) | 11 to 14 V |
| Power switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L130-7 (GND) - Body ground | Always | Below 1 Ω |
OK
NG
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L130-9 (PRST) - L61-7 (SIL) | Always | Below 1 Ω |
| L130-9 (PRST) or L61-7 (SIL) - Body ground | Always | 10 kΩ or higher |
OK
NG
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L61-4 (CG) - Body ground | Always | Below 1 Ω |
OK
(See pageVehicle Exterior>VEHICLE PROXIMITY NOTIFICATION SYSTEM>VEHICLE APPROACHING SPEAKER ECU>REMOVAL)
NG