84431
1.INSPECT VEHICLE APPROACHING SPEAKER SWITCH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 11 (ECU) - 8 (IG) | Vehicle approaching speaker switch on | Below 1 Ω |
| Vehicle approaching speaker switch off | 10 kΩ or higher |
| *a | Component without harness connected
(Vehicle Approaching Speaker Switch) |
If the result is not as specified, replace the vehicle approaching speaker switch.
Check that the indicator illuminates.
Apply voltage from the auxiliary battery to the vehicle approaching speaker switch and check that the indicator illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 8 (IG)
Auxiliary battery negative (-) → Terminal 12 (IND) |
Illuminates |
If the result is not as specified, replace the vehicle approaching speaker switch.
Check that the switch illuminates.
Apply voltage from the auxiliary battery to the vehicle approaching speaker switch and check that the switch illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 10 (ILL+)
Auxiliary battery negative (-) → Terminal 9 (ILL-) |
Illuminates |
If the result is not as specified, replace the vehicle approaching speaker switch.