Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › 2014.11–2015.08
RM2070E _53 Suspension _061921 TIRE PRESSURE MONITORING _0301678 TIRE PRESSURE WARNING SYSTEM Y

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the tire pressure warning system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
a.

Interview the customer to confirm the problem.

HINT:

It is important to collect as much specific information as possible from the customer to allow for a quick repair.



Result:
Proceed to
NEXT



NEXT

3.ADJUST TIRE PRESSURE*
3.ADJUST TIRE PRESSURE*
a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG).


d.

Enter the following menus: Chassis / Tire Pressure Monitor / Data List.


e.

Set the tire pressure to the specified value (See page Suspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION).

NOTICE:

Make sure the tires are cool when adjusting the tire pressure.



f.

Display "ID Tire Inflation Pressure" in the Data List and check that the tire pressure values match the adjusted pressure amount.

HINT:

It may take a few minutes until the values are displayed.



g.

Perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION).

Result:
Condition Proceed to
Tire pressure warning light remains on A
Tire pressure warning light goes off B


HINT:

The warning threshold value changes depending on the driving conditions during initialization. As a result, the tire pressure warning light may not turn off even if the tire pressure is adjusted to the specified pressure.




A

4.CHECK FOR DTC*

B

END

4.CHECK FOR DTC*
a.

Check for DTCs (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTCs are output A
DTCs are not output B




A

5.DTC CHART

B

6.PROBLEM SYMPTOMS TABLE
5.DTC CHART

Result:
Proceed to
NEXT



NEXT

8.REPAIR OR REPLACE
6.PROBLEM SYMPTOMS TABLE

Result:
Proceed to
NEXT



NEXT

7.CIRCUIT INSPECTION*
7.CIRCUIT INSPECTION*

Result:
Proceed to
NEXT



NEXT

8.REPAIR OR REPLACE
8.REPAIR OR REPLACE
a.

Repair or replace parts based on the diagnosis result.


Result:
Proceed to
NEXT



NEXT

9.CONFIRMATION TEST*
9.CONFIRMATION TEST*
a.

Check the Data List to confirm that the tire inflation pressure has been received (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST).



c.

Confirm that the initialization has been completed.


Result:
Proceed to
NEXT



NEXT

END